The Static Stretcher Forums

[John Longwood]

Hey.
Is there any limits to how long you can wear the static press-vac? I'm especially thinking about blisters like long continous use fromt the static vac could produce.

[John Longwood]

Since a short break of giving up I tried the press-vac and static vac again. I seem to run into the same problem over and over again! I'm suprised no one else seems to have this many problems with it.

No matter how hard I try to pull excess skin back before applying either of the to it seems like I get the effect of lose skin and the press-vac simply slides off, while the static vac sort creates air space inside the dome and eventually slides of as well.

Do you have any suggestions to solve this or should I just keep on trying? Because I'm close to giving up, but at the same time I won't let myself!

[admin]

There is no specific limit to how long you can wear the press-vac. It is very odd that it is sliding off. It seems that would be impossible given how sticky it is.

1) Are you completely applying it (without an air pocket)?
2) Is it clean?
3) Have you tried rolling it up and then applying it to the glans and unrolling slowly pulling your skin back as you go?
4) Have you tried cutting one of them shorter so that you can fully apply it?

[John Longwood]

I'm following the video very exact and that includes rolling the static-vac up. It's not that weird as you show in the movie that if any exces skin is in there the sleeve will come of when you pull it. That's the problem I have I guees, since I can feel the foreskin rollover the glans once as I pull on the static-vac. But I'm doing everything I can to get excess skin out of static-vac but somehow it's not enough.

I haven't tried cutting it yet, but I have the same problem with the dome and the comprehension sleeve, which I've tried to cut several times untill it was to short. The foreskin simply gets rolled back over the glans everytime.

[John Longwood]

I mixed up static vac with the press-vac, hope you get the point anyway

[admin]

Have you tried using the supplied medical tape to hold back the skin while putting on either device?

[urenui]

Hmmm.
I had a problem of the Vac dome falling off and it was due to a hole in the sleeve. Moved the hole out of the vac zone and it's now fine.

I use the black static-press vac sleeve for everything: static, medium and dome. I have a goodly amount of foreskin, and I'v found only that sleeve will keep it under control.

My application technique is a little different to the vid's where I roll it as if it were from a roll of say wallpaper, than if say from a roll of clothing material (which is often a flat oblong 'roll'). I also make sure my head is full of blood before I apply so there is little to no air in that distal end. Has helped prevent blisters to a large extent. Then as I roll it down i pull the foreskin away from in front of it. (I need to as at full streeeetch there is only just enough skin to do the length.

It took me about 3 months to perfect this technique which works for me.
_________________
Uncut. Bought All-in-One Dec 09.
Using them (almost) daily since then. BPELs in mm:
Dec 09 192 (start)
2010: Jan 205; Feb 215; Mar 216; Apr 220

[John Longwood]

That's interesting urenui. How exactly do you use the static press vac with the dome? Do you wear it underneith the dome and the bio-adhesive?

I'm not sure I understand your technique. Could you elaborate?

Thanks for your help!

[urenui]

Hi John

Given that PMs and attachments are disabled here, send me an email to this address:

pe kape ka2 5 @yah oo.com
(remove all the spaces

I'll send you some pics of what I am referring to.

Cheers
_________________
Uncut. Bought All-in-One Dec 09.
Using them (almost) daily since then. BPELs in mm:
Dec 09 192 (start)
2010: Jan 205; Feb 215; Mar 216; Apr 220

[John Longwood]

[urenui]